Huawei FusionModule2000 - Page 184

FusionModule2000 Smart Modular Data Center
Product Description
8 Intelligent Module Management System
Issue 06 (2020-05-21)
Copyright © Huawei Technologies Co., Ltd.
176
Specifications
Table 8-42 Access actuator technical specifications
Item
Specifications
Power input

DC input: Terminal, with input voltage of 36–60 V DC

POE input: One POE port that complies with IEEE802.3at.
POE port
FE communication, 10/100M communications rate
Wireless
communication
One wireless communication port that complies with IEEE802.15.4,
mutual backup with FE communication
AI/DI port
Two AI/DI ports, can connect to the fire alarm and exit button
DO/DI port

One 12 V DC power output that controls magnetic locks, terminal

One DI input port for connecting to the door status switch
RS485 serial port
expansion
Two RS485 ports (one route) with the default communications rate of
9600 bit/s, physical port cascading supported (reserved function)
Wiegand interface
Two Wiegand interfaces, 12 V DC card reader operating power
output; two routes of card readers (non-fingerprint readers) can
operate at the same time.
BLINK button

Press the button for less than 1 second to start blinking.

Hold down the button for 1–5 seconds to search for a network and
start networking.

Hold down the button for more than 10 seconds to clear network
parameters.
Address DIP
switch
4-pin address DIP switch
E-label
Supported
Indicators
Table 8-43 Access actuator indicator description
Indicator
Color
Name
Status
PWR
Green
Power input status
indicator

Steady on: The power
input is normal.

Off: There is no
power input.
RUN
Green
Communication status
indicator

Off: The power is
abnormal or the
board program is
loading.

Blinking at long