Procedure
Step 1 Install the holding rails.
1. Holding down the release latch at the front end of the holding rail, pull out
the locking plate by its hook. See (1) and (2) in Figure 3-9.
Figure 3-9 Installing a holding rail
2. Aligning the screws on the back end of the holding rail with the mounting
holes of the cabinet, insert the rail into position so that the latch clicks into
place. See (3) in Figure 3-9.
3. Aligning the top screw on the front end of the holding rail with the level
mounting hole of the cabinet, insert the rail into position. See (4) in Figure
3-9.
4. Push back the locking plate by its hook until the release latch clicks into
place. See (5) in Figure 3-9.
5. (Optional) Secure the back end of the rail with an M6 screw through the
corresponding mounting hole in the cabinet. See (6) in Figure 3-9.
6. Install the other holding rail using the same method.
Step 2 Install the server.
1. Pull out the inner rails as far as they will go. See Figure 3-10.
RH2288H V3 Server
User Guide 3 Installing and Removing the RH2288H V3
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 89
To Next Page
Loading...
