Step 6 Connect cables to the DVD drive. See step (3) in Figure 7-52.
If fan modules have been installed, remove them and the fan support before connecting
cables.
Step 7 Install the fan module brackets in the chassis. See Figure 7-53.
Figure 7-53 Installing fan module brackets
Step 8 Install the fan modules. For details, see 7.16 Installing a Fan Module.
Step 9 Install the air duct. For details, see 7.14 Installing the Air Duct.
Step 10 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 11 Install the RH2288H V3. For details, see 3.4 Installing the Server.
Step 12 Connect all external cables such as power and network cables. For details, see 3.5
Connecting External Cables.
Step 13 Power on the RH2288H V3. For details, see 4.1 Powering On the Server.
----End
With Eight 3.5-inch Hard Disks
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Remove the DVD drive to be replaced. For details, see 7.25 Removing the DVD
Drive.
Step 3 Take the spare DVD drive out of its ESD bag.
Step 4 Tighten two M2
at-head screws using the Phillips screwdriver to secure the
plastic latch to the DVD drive. See step (1) in Figure 7-54.
RH2288H V3 Server
User Guide 7 Replacing Parts
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 195
To Next Page
Loading...
