Server with Eight 3.5-inch Hard Disks
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the cabinet number and chassis number of the server, and label its
panel to prevent misoperations.
Step 3 Power o the RH2288H V3. For details, see 4.2 Powering O the Server.
Step 4 Remove all external cables such as power and network cables.
Step 5 Remove the RH2288H V3 and put it on an ESD desktop. For details, see 3.6
Removing the Server.
Step 6 Remove the chassis cover. For details, see 7.11 Removing the Chassis Cover.
Step 7 Remove full-height full-length riser cards if they are installed. For details, see 7.19
Removing the Riser Card.
Step 8 Remove the air duct. For details, see 7.13 Removing the Air Duct.
Step 9 Remove the fan modules. For details, see 7.15 Removing a Fan Module.
Step 10 Press and hold down the latches on both sides of a fan support, and lift the fan
support. Use the same method to lift the other fan support. See steps (1) and (2)
in Figure 7-106.
Figure 7-106 Removing a fan support
Step 11 Remove the cable between the LCD and the video graphics array (VGA) port. See
step (1) in Figure 7-107.
RH2288H V3 Server
User Guide 7 Replacing Parts
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 245
To Next Page
Loading...
