Figure 7-150 Installing the VGA board on a server with eight 3.5-inch hard disks
Step 5 Tighten the screws to secure the VGA board to the panel. See step (2) in Figure
7-150.
Step 6 Connect cables to the VGA board.
Step 7 Push the panel into the server in the arrow direction. See step (3) in Figure 7-150.
Step 8 Tighten the screws on the server. See step (4) in Figure 7-150.
If fan modules have been installed, remove them and the fan support before tightening the
screws.
Step 9 Connect all cables between the VGA board and the DVD drive or LCD. For details,
see 2.7 Internal Cabling.
Step 10 Install the fan module brackets in the chassis. See Figure 7-151.
RH2288H V3 Server
User Guide 7 Replacing Parts
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 282
To Next Page
Loading...
