v 1.4 — September 2015 Altanium Neo2
54 Running ART on a Zone
NOTE:The system must be in run mode before a zone can be Re-ARTed.
To ART a zone:
1. On the Quick Set screen, touch the zone to ART.
To select more than one zone, touch the additional zones and they will be selected.
2. Touch Re-ART and the tuning process will begin on the selected zones.
During the ART process the following will be displayed on the zone data buttons:
• 6 Zone Layout — zone number, zone name and ART in the middle of the button.
• 12 Zone Layout — zone number, zone name and ART in the middle of the button.
• 24 Zone Layout — zone number and ART in the middle of the button.
• 48 Zone Layout — zone number and ART in the middle of the button.
The time it takes to ART on a zone is dependent on the time it takes for the heater to heat
up. Small heaters will be the fastest and large manifold heaters will take more time.
To Next Page
Loading...
