Installation
XPR300 Instruction Manual 809480 11 9
Connect supply gases to the gas connect console (Core)
WARNING
MISSING CHECK VALVES CAN CAUSE AN EXPLOSION OR FIRE
Never remove a check valve.
An explosion or fire can occur if the cutting system is operated without check
valves.
NOTICE
PTFE TAPE CAN CAUSE CLOGGED VALVES, REGULATORS, AND TORCHES
Never use PTFE tape on any joint preparation. Use only a liquid or paste thread sealant on male thread
ends.
CAUTION
INCORRECT HOSES, CONNECTIONS, OR FITTINGS CAN CAUSE DAMAGE AND BAD
PERFORMANCE
All hoses, hose connections, and hose fittings used for supply-gas plumbing must be designed for use
with the appropriate gas and pressure rating. Incorrect hoses, hose connections, or hose fittings can
crack or leak.
NEVER connect a supply gas to a hose, connection, or fitting that is not designed for that gas type or
pressure.
A replacement hose, connection, or fitting must meet all applicable regulations and codes.
Non-compliant hoses, hose connections, or hose fittings can crack or leak.The wrong fittings can cause
malfunctions with the internal valves because contaminants can enter the valves through damaged or
loose fittings.
CAUTION
INCORRECT SUPPLY-GAS FITTINGS CAN CAUSE VALVES TO MALFUNCTION
Do not change or replace the supply-gas fittings on the gas connect console.
If you alter or replace the fittings, it can cause the internal valves to malfunction if particulates get inside.
To Next Page
Loading...
Need help?
General
