Hypertherm XPR300 User Manual

Installation
3
98 809480 Instruction Manual XPR300
Oxygen hose (blue)
Nitrogen hose (black)
Air hose (black)
Hydrogen (OptiMix only) (red)
Argon (VWI or OptiMix only) (black)
F5 (VWI or OptiMix only) (red)
Shield water (VWI or OptiMix only) (blue)
Use a hand-over-hand motion to uncoil the hoses, cables, and
leads. As you uncoil them, position the flat portion on the floor.
To avoid equipment damage, do not pull from one end of the
hose, cable, or lead to uncoil it. Pulling from one end can cause
damage.

Hypertherm XPR300 Specifications

General

Cutting Current	300 A
Duty Cycle	100% at 300 A
Technology	X-Definition Plasma
Gas Supply	Oxygen, Nitrogen, Air
Cutting Capacity (Mild Steel)	38 mm (1.5 in)
Severance Capacity (Mild Steel)	75 mm (3 in)
Pierce Capacity (Mild Steel)	50 mm (2 in)
Input Voltage	200–480 V, 3-PH, 50/60 Hz