Hypertherm XPR300 - Remove the Power from the Cutting System

Maintenance
7
240 809480 Instruction Manual XPR300
Remove the power from the cutting system
WARNING
ELECTRIC SHOCK CAN KILL
Disconnect electrical power before doing installation or maintenance.
The line-disconnect switch must REMAIN in the OFF position until all
installation or maintenance steps are complete.
In the United States, use a “lock out/tag out” procedure until installation or
maintenance is complete. In other countries, follow the appropriate national
and local safety procedures.
Refer to the Safety and Compliance Manual (80669C) for more safety
information.
WARNING
ELECTRIC SHOCK CAN KILL
The plasma power supply contains dangerous electric voltages that can seriously injure or
kill you.
Even if the plasma power supply is turned OFF, you can still get a serious electric shock if
the plasma power supply remains connected to an electric power source.
Use extreme caution if you do diagnosis or maintenance tasks when the plasma power
supply remains connected to an electric power source and the outer cover or panels are
removed.
WARNING
MACHINE MOTION CAN CAUSE INJURY
The end-use customer and the cutting machine supplier are responsible for providing
protection against the hazardous moving parts of this cutting system.
Read and follow the instruction manual provided by the cutting machine supplier.
See the Safety and Compliance Manual (80669C) for more safety information.