Hypertherm XPR300 User Manual

Installation
3
102 809480 Instruction Manual XPR300
Connect the power cable
Figure 14 – Power cable

For lengths, refer to Power cable on page 394 of the Parts List.
Figure 15 – Connect the power cable
To plasma power supply (male cable connector) To gas connect console (female cable connector)
Plasma power supply
Gas connect console
Use your fingers to tighten these connectors.
Do not use tools.

Hypertherm XPR300 Specifications

General

Cutting Current	300 A
Duty Cycle	100% at 300 A
Technology	X-Definition Plasma
Gas Supply	Oxygen, Nitrogen, Air
Cutting Capacity (Mild Steel)	38 mm (1.5 in)
Severance Capacity (Mild Steel)	75 mm (3 in)
Pierce Capacity (Mild Steel)	50 mm (2 in)
Input Voltage	200–480 V, 3-PH, 50/60 Hz