Hypertherm XPR300 - Requirements to Position System Components

Qualifications and Requirements
2
XPR300 Instruction Manual 809480 57
Requirements to position system components
When you plan where to position the plasma power supply, gas connect console, torch connect
console, and torch, use the following limitations and requirements:
 Site requirements on page 60
 Length requirements for hoses, cables, and leads on page 60
 Bend radius requirements for hoses, cables, and leads on page 61
 Distance requirements between high-frequency leads and control cables on page 62
 Distance requirements for ventilation and access on page 62
 Distance requirements for communications on page 63