XPR300 Instruction Manual 809480 199
Coolant Installation
Overview
The cutting system ships without coolant in the reservoir. Before you operate the cutting system,
you must fill it with coolant. The coolant capacity for the XPR cutting system is between
22.7 liters – 45.4 liters (6 US gallons – 12 US gallons).
A cutting system with long leads requires more coolant than a cutting system with short leads.
Contact your cutting machine supplier to reorder coolant. For information
about how to calculate the approximate total volume of coolant for your
cutting system, refer to Estimate the total coolant volume for your cutting
system on page 254.
The plasma power supply ships with the coolant filter (027005) and
coolant pump screen (127559) installed. Additional coolant filters and
screens are available from Hypertherm. Refer to Coolant system on
page 364.
For information about how to install a replacement coolant filter or coolant
pump screen, refer to the XPR Preventative Maintenance Program (PMP)
Instruction Manual (809490).
To Next Page
Loading...
