Hypertherm XPR300 User Manual

Specifications
1
XPR300 Instruction Manual 809480 37
IEC symbols
The following symbols can appear on the data plate, control labels, and switches.
Direct current (DC)
Alternating current (AC)
Plasma torch cutting
Gouging
AC input power
connection
The terminal for the
external protective (earth)
(PE) conductor
I Power is ON
O Power is OFF
A 1-phase or 3-phase
inverter-based power
source
Volt/amperage curve,
“drooping” characteristic
f
1
f
2
1~

Hypertherm XPR300 Specifications

General

Cutting Current	300 A
Duty Cycle	100% at 300 A
Technology	X-Definition Plasma
Gas Supply	Oxygen, Nitrogen, Air
Cutting Capacity (Mild Steel)	38 mm (1.5 in)
Severance Capacity (Mild Steel)	75 mm (3 in)
Pierce Capacity (Mild Steel)	50 mm (2 in)
Input Voltage	200–480 V, 3-PH, 50/60 Hz