Hypertherm XPR300 User Manual

Connect for Communication
4
XPR300 Instruction Manual 809480 161
1. Use a 10 mm hex socket wrench or nut driver to remove the rear panel of the plasma power
supply.
Figure 46

Hypertherm XPR300 Specifications

General

Cutting Current	300 A
Duty Cycle	100% at 300 A
Technology	X-Definition Plasma
Gas Supply	Oxygen, Nitrogen, Air
Cutting Capacity (Mild Steel)	38 mm (1.5 in)
Severance Capacity (Mild Steel)	75 mm (3 in)
Pierce Capacity (Mild Steel)	50 mm (2 in)
Input Voltage	200–480 V, 3-PH, 50/60 Hz