IAI ELECYLINDER EC-S13 - Brake Release Wiring; Wiring Connections (for Cables); Power IO Cable

3.4 Wiring connections (for connectors)
3.5 Wiring connections (for cables)
3-32
3. Wiring
Brake release wiring
For the specification with brake, when installing a forcible brake release switch, connect wiring
to the [B2] connector terminal.
Power capacity of 24V DC ±10% / 0.875 A (when in overexcitation), 0.085 A (when steady) is
required.
Pin
No.
Connecto
r
nameplate
name
Signal
abbreviation
Compatible
wire diameter
Required specifications
B2
Brake
release
BKRLS
KIV 0.20 mm
2
(AWG24)
24 V DC ±10% /
0.875 A (when in overexcitation)
0.085 A (when steady)
3.5 Wiring connections (for cables)
Here the wiring connection method with a power I/O cable is introduced.
Power I/O cable
Note1 TMD2 is 24V (control)
(Note) Cable in light green and light gray not in use
ST0
ST1
RES
*ALM