6.2 How to change parameters
6-2
6. Parameters
6.2 How to change parameters
A teaching pendant or PC software can be used to change parameters. This manual introduces
operating methods using a teaching pendant TB-02.
PC software operating method PC software manual (ME0155)
Teaching pendant operating method Teaching pendant manual (ME0355)
Touch panel teaching pendant operation Touch panel teaching pendant manual
method (ME0375, ME0376)
Edit parameters window
Touch Parameter edit on the Menu 1 screen.
The screen will switch to the Edit parameters
window.
If the TP operation mode is not Monitor mode,
a confirmation window will appear for switching
to Monitor mode.
Also, if the parameter edit password is set to a
value other than "0000", the password input screen will be displayed.
If the parameter edit password is set to a value
other than "0000", enter the password and press
the [ENT] key on the touch panel.
The Edit parameters window will open.
The parameter edit password is set to "0000" at shipping.
Refer to the Teaching pendant manual (ME0355) / Touch panel teaching
pendant manual (ME0375, ME0376) for information about changing the
password.
1
Action
2
Action
Reference
Reference
To Next Page
Loading...
Need help?
General