2.3 Installation of Slider type
2-9
2. Installation
Mounting transported objects
● Use the tapped mounting holes on the top surface of the slider to fix transported objects.
● There are 2 reamed holes on the top surface of the slider.
Use these reamed holes if repeated attaching and detaching is required.
● If fine-tuning of perpendicularity, etc. is required, use one of the reamed holes for this
adjustment.
● Refer to the figure below for the screw-in depth and reamed hole depth.
→ Refer to “Chapter 9 External Dimensions” for details.
Type
A
(mm)
B
(mm)
Reamed hole
EC-S13
EC-S13X
120 90 φ8H7 depth 10
EC-S15
EC-S15X
150 90 φ8H7 depth 10
Caution
Be careful with regard to the length of the mounting bolt and positioning pin.
The use of screw-in depth greater than that of the tapped or reamed mounting holes may
damage the tapped hole or reduce the mounting strength of the transported object,
leading to decreased accuracy or unexpected accidents.
Notice
● The mounting bolts are to be prepared by the customer.
● The use of high-strength bolts of ISO-10.9 or higher is recommended.
To Next Page
Loading...