1.3 Options
1-27
1. Specifications
1.3 Options
RCON-EC connection specification (Model: ACR)
It is the code to be indicated when connected to RCON-EC.
When this option is selected, it is not available to select PN Option (PNP specification) or TMD2
Option (Two-circuit power supply specification).
With brake (Model: B)
This is used to prevent the slider from moving during power outages or when the servo is OFF.
It can also be used to prevent the slider from falling when mounted vertically.
Indicated grease applied type (Model: G5)
Grease applied on the ball screw and linear guide on the actuator can be changed to food
machinery grade grease (White Alcom Grease).
Home reverse specification (Model: NM)
The standard home position is on the motor side.
However, the opposite side specification is selected if the home position direction is reversed in
accordance with equipment layout or assembly direction.
PNP specification (Model: PN)
I/O input/output specifications are NPN specification as standard.
Specifying this option changes the unit to PNP specification.
Wireless communication specification (Model: WL)
The models with wireless communication specification have built-in wireless circuit boards and
enable wireless communication between ELECYLINDERs and Touch Panel Teaching Pendant.
Certificates and self-declarations regarding the wireless function are handled under the model
name below for the wireless circuit board.
Model name: IABL3826
To Next Page
Loading...