IAI ELECYLINDER EC-S13 - Body Mounting

2.3 Installation of Slider type
2-8
2. Installation
Body mounting
This actuator is equipped with through holes for attachment so it could be affixed from
the top.
→ For details regarding the position and dimensions, refer to "Chapter 9 External
Dimensions".
There are a reamed hole and an oblong hole for the positioning pins.
Use the reamed hole and oblong hole if mounting reproducibility after detachment is
required.
When fine adjustment of angles, etc. is required, consider using only the reamed hole.
Type
A
(mm)
B
(mm)
C
(mm)
D
(mm)
E
(mm)
EC-S13
EC-S13X
109 φ9 41.5 φ14 50
EC-S15
EC-S15X
133 φ9 41.5 φ14 50
Type Reamed hole Oblong hole
EC-S13
EC-S13X
φ8H7 depth 10
(From base seat surface)
F: 8 G: 10 depth 10 mm or less
EC-S15
EC-S15X
φ8H7 depth 10
(From base seat surface)
F: 8 G: 10 depth 10 mm or less
+0.015
0
+0.015
0
Reamed hole
G
F
Oblong hole