11P4758 Frame tie-down Kit (Long - Raised Floor) (RPQ 8A1186)
Item Part Number Qty Description
Illustration on page 114. 44P0674 4 Turnbuckle Assembly (long)
Item 3 in illustration on page 109. 11P3527 2 Shipping bar (lower)
Item 5 in illustration on page 109. 11P3529 4 Hinge plate
Item 8 in illustration on page 109. 11P3530 2 Latch plate
Item 6 in illustration on page 109. 11P3531 2 EQ support
Item 2 in illustration on page 109. 11P3532 2 Shipping bar (upper)
Item 7 in illustration 109. 76X4687 2 Latch bolt
Item 1 in illustration on page 109. 1624804 20 Screw (hex flange, 20mm, long)
Item 9 in illustration on page 109. 1621546 8 Screw (hex, 25mm, long, hinge)
Item 10 in illustration on page 109. 1622307 8 Washer (M8, hinge)
Mounting Internal Rack Components: To mount the internal rack components, do the following:
Attention: This procedure is performed by the service representative.
1. Using four M-8 (20 mm) screws (item 1 in illustration on page 109), install the top shipping bar (item
2 in illustration on page 109) at EIA unit location 32.
2. Using four M-8 screws (item 1 in illustration on page 109), install the bottom shipping bar (item 3 in
illustration on page 109) at EIA unit location 18.
3. Repeat steps 1 and 2 to install shipping bars in the rear of the rack.
4. Attach the front top hinge (item 5 in illustration on page 109) on the vertical rail (located
approximately at EIA unit 29-30 on the vertical rail) with two 25 mm screws (item 9 in illustration on
page 109) and two washers (item 10 in illustration on page 109).
5. Attach the front bottom hinge (item 5 in illustration on page 109) on the vertical rail (located
approximately on EIA unit 6-7 on the vertical rail) with two 25 mm screws (item 9 in illustration on
page 109) and two washers (item 10 in illustration on page 109).
6. Repeat steps 4 and 5 to install the hinges on the rear rail.
7. Attach the latch plate (item 8 in illustration on page 109) with two M-8 (20 mm) screws (item 1 in
illustration on page 109).
8. Repeat step 7 to attach the latch plate in the rear of the rack.
9. Attach the triangular braces (item 6 in illustration on page 109) in both the front and rear of the rack.
10. Install the latch bolts (item 7 in illustration on page 109).
108 Site and Hardware Planning Information
To Next Page
Loading...
Need help?
General