Troubleshooting tables 51
Printer error 1.Make sure the printer cable is correctly and securely connected to the printer
and to the parallel (printer) port on the back of the system unit.
The printer port has this symbol next to it to help you:
2.Make sure the printer power cord is securely connected to an electrical outlet.
3.Make sure the printer is ready for printing. (If the Ready light is on, but not
flashing, the printer is ready.)
4.Make sure the correct printer driver is selected in the software, if required. For
instructions on selecting a printer driver, see “Installing a printer driver” on
page 15.
5.Make sure the paper and the cartridge containing the print material (ink,
ribbon, or toner) are loaded correctly.
6.Turn the printer and system unit off, and wait 10 seconds. Now turn the
printer on first, and then the system unit.
7.Make sure the Parallel Port option is not set to “Disabled” in the Input/Output
Ports feature of the Setup Utility.
8.Make sure the Parallel Port Mode option is set to a mode that matches your
printer.
9.For additional help, see the user’s guide that came with the printer.
Table 6: Troubleshooting: Hardware problems (Continued)
If the problem is: Here’s what to do:
Note: If any of these problems continue after taking the actions listed, check your A Guide to HelpWare and All the Extras folder
for information on obtaining service.
bi2gntce.bk : bi2gsolv.doc Page 51 Saturday, June 3, 1995 6:54 AM
To Next Page
Loading...
Need help?
General
