Error codes, descriptions, and corrective actions 65
962 Parallel Port Configuration
Error
If you changed a hardware option, press Enter while the error message is
displayed to enter the Setup Utility. Choose Input/Output Ports from the Setup
Utility Main Menu and verify that the Parallel Port setting is correct. If the
setting is not correct, change the setting. For instructions on using the Setup
Utility, see page 69.
1162 Serial Port Configuration
Error
If you changed a hardware option, press Enter while the error message is
displayed to enter the Setup Utility. Choose Input/Output Ports from the Setup
Utility Main Menu and verify that the Serial Port settings are correct. If the
settings are not correct, change the settings. For instructions on using the
Setup Utility, see page 69.
1362 Mwave Sound Card
Configuration Error
Make sure the I/O adapter settings in the Mwave Hardware Configuration utility
match the jumper settings on the Mwave adapter card. For instructions on
changing Mwave adapter card settings, see “Changing modem addresses for
the Mwave adapter card” on page 32.
1762 Hard Disk Configuration Error 1.Make sure the cables to all drives are securely attached.
2.Press Enter while the error message is displayed to enter the Setup Utility.
Choose Disk Drives from the Setup Utility Main Menu. Make sure the settings
for the drive options are correct. If the settings are not correct, change the
settings. For instructions on using the Setup Utility, see page 69.
Table 10: Error codes, descriptions, and corrective actions (Continued)
Error Code Description Here’s what to do:
Notes:
1.An X shown as part of the error code in this table represents any number between 0 and 9.
2.If any of these errors continue after taking the actions listed, check your A Guide to HelpWare and All the Extras folder for
information on obtaining service.
bi2gntce.bk : bi2gsolv.doc Page 65 Saturday, June 3, 1995 6:54 AM
To Next Page
Loading...
Need help?
General
