IDEC SmartRelay Series - Page 197

IDEC SmartRelay functions
IDEC SmartRelay Manual 187
Confirm your changes with OK. You can now edit further pa-
rameters in the message text (if any exist). Press ESC to exit
editing mode.
Key input simulation in the active message text
You can enable the four cursor keys C▲, C , C▼ and C
in an active message text by pressing ESC plus the relevant
cursor key.
Preset of the Par parameter
To configure the message text (programming mode):
Press to select a line for the message text.
Press ▲ or ▼ to select the relevant type of message text
(Text, Par, Time...). Confirm with OK.
Further entries are required when “Text” or “Par” are select-
ed:
Press ▲ or ▼ to select the letter to be displayed in the text.
To move the cursor from one position to the other, press
or .
The list of available characters is here the same as for the
circuit program name. The character set is found in Chapter
3.6.4.
Press OK to confirm your changes, and press ESC to exit
the editing mode.
▲
▲
..
..
..
..
Parameter assignment
screen form for Par
▲
▲
▲
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com