5 - ADJUSTMENTS AND SETTING-UP BOSS 332/545/552 HD
EN
5 - Pag. 19 / 34
• Assemble the top guide channels first, and then the
lower guide channels suitable for the bar.
INFORMATION:
make sure that the lower guide channel screws
have an oil inlet hole.
• Choose the right collet for the bar; refer to the
"GUIDE CHANNELS - BAR PUSHERS - REVOLVING
TIPS - COLLETS" section.
INFORMATION:
contact IEMCA service department for
further information.
Legend:
1 "IEMCA" pipe collet
2 "IEMCA" bar collet
3 "IEMCA" collet for bars machined with front
remnant ejection
4 Quick coupling collet for bars
5 Ring
6 Collet connection
To Next Page
Loading...
