4 - HANDLING AND INSTALLATION BOSS 332/545/552 HD
EN
4 - Pag. 9 / 32
• Roughly adjust the height of the working axis and
the alignment with the lathe by turning the
screws of the support feed.
4.4.4 Sleeve - Installation
BOSS 332
• Install the sleeve "A" in the bush holder device.
• Install the oil recovery tank "B".
• Connect the drain pipe to the tank.
DANGER - WARNING: Please, note that,
by removing the telescopic front nose,
the bar feeder might be DANGEROUS to
the operator and/or installation
technician due to bar pusher extension.
To Next Page
Loading...
