EN
5 - ADJUSTMENTS AND SETTING-UP BOSS 332/545/552 HD
5 - Pag. 4 / 34
5.3 SETUP ACCORDING TO THE BAR TO BE MACHINED
According to the diameter of the "new" bar to be machined, a few or several operations must be
carried out based on the diameter of the previously machined bar.
The table reports the diameters of available guide channels as well as the range of the bar
pushers that can be assembled, and the diameters of the bar to be machined.
BOSS 332 guide channel, bar pusher, bar and pipe diameters.
Bar diameter (mm)
Model
Guide
channel
diameter
(mm)
Bar pusher
diameter
(mm)
Minimum Maximum
Max. pipe
diameter
(mm) (*)
10 3 8 10
13
12 4 10 12
15 5 13 15
17
16 5 14 16
18 5 16 18
19 5 17 19
21
20 5 18 20
24 23 6 20 23
23 8 21 23
26
25 8 23 25
25 8 23 25
28
27 8 25 27
30 8 27 30
31 8 28 31
33
32 8 29 32
32 8 29 32
BOSS 332
36
35 8 32 32
(*) Valid also for prepared bars or normal bars machined with front remnant ejection.
To Next Page
Loading...
