7 - BAR FEEDER MAINTENANCE BOSS 332/545/552 HD
EN
7 - Pag. 7 / 8
7.3 AXIAL DISPLACEMENT DEVICE - USE
• If the bar feeder is fixed to the lathe, release it.
Disconnect any installed devices (e.g. the bar -
headstock synchronization device, the cam box,
the camshaft release device, etc.).
• Remove the eight screws "A".
• Insert the (supplied) rod "B" in its hole, turn
the shaft "C" and insert the (supplied) pin "D".
• Make the bar feeder slide backwards. Be
careful not to damage any connection wires
(e.g. the lathe interface power lead, the
camshaft disengagement device cable, the
handheld keyboard cable, the pneumatic
connection cable, etc).
• Carry out all lathe maintenance operations.
• Make the bar feeder slide forwards and restore
its initial conditions.
To Next Page
Loading...
