4 - HANDLING AND INSTALLATION BOSS 332/545/552 HD
EN
4 - Pag. 31 / 32
4.9.3 FUNCTION SIGNALS
The bar feeder can send and receive all the signals which are necessary to its correct operation.
These signals are driven by a PLC, and can be grouped into: inputs (signals from lathe to bar
feeder) and outputs (signals from bar feeder to lathe).
The signals that have been implemented are the result of our long experience and allow the
connection with every type of lathe: it is therefore possible that only some of them are used.
IMPORTANT:
for further information, please refer to the interface wiring diagram supplied
with the bar feeder, or contact: our Customer Service and Engineering
Department, which is always at your disposal.
To Next Page
Loading...
