11 - COLLETS BOSS 332/545/552 HD
EN
11 - Pag. 13 / 34
11.10 PIPE COLLETS 012-077-377
11.11 PIPE COLLETS - Table
WARNING – CAUTION:
the collet external diameter should be at least 0.5 mm smaller than the bar
pusher external diameter.
INFORMATION:
collets 377... (bar feeder BOSS) with øF M10x1 have been designed to be
assembled on lower revolving tips with ø28; if fitted on the revolving tips with
diameter greater than ø30 and with nipple 078800030, it is necessary to
increase the bar pusher carriage first feeding value by 7.5 mm.
INFORMATION:
upon specific request, non standard collets with reduced thickness (which are
not mentioned in this table) may be supplied as well. Their durability is however
below the durability of standard collets.
Code structure
CH*: double-ended fork wrench DIN3110
To Next Page
Loading...
