EN
6 - USE AND OPERATION BOSS 332/545/552 HD
6 - Pag. 18 / 24
6.5.5 Mode of performing a cycle in the STEP BY STEP function
Foreword
This mode may be used for many reasons, as for instance:
• to check a complete bar change cycle;
• to check the bar feeder mechanics;
• to load a single bar so as to check the facing;
• etc.
Procedure
• press
to start the bar feeder;
• Check that the bar feeder is in the closed guide channel condition.
• press
and to select the semiautomatic function;
• press and the bar feeder performs the first step;
• press and the bar feeder performs the second step, and so on.
6.6 BAR FEEDER STOP
BAR FEEDER EMERGENCY STOP
WARNING – CAUTION:
if the emergency stop is activated whilst the lathe is working, before restarting
the working cycle, check that no dangerous conditions have been created due to
the sudden stop.
Example: if the tool was removing chips, before restarting the lathe, distance
the tool from the piece.
• To stop the bar feeder in emergency, press one of the emergency buttons of the bar feeder
or lathe.
BAR FEEDER STOP AT THE WORKING CYCLE END
WARNING – CAUTION:
when stopping the machine normally, do not use the emergency buttons.
• Complete the operations in your working schedule.
To Next Page
Loading...
