IEMCA BOSS 545 E - 8.1 GENERAL FAILURES
; 8.2 BAR MAGAZINE ΠFailures

8 - TROUBLES - CAUSES - CURES BOSS 332/545/552 HD
EN
8 - Pag. 3 / 4
8.3 FEEDING INTO COLLET – Failures
TROUBLES CAUSES SOLUTIONS
Collet diameter not suitable
for bar diameter
Change collet
Bar fails to enter collet
Excessive rag on bar rear end Trim rag before feeding
8.4 BAR FEEDING - Failures
TROUBLES CAUSES SOLUTIONS
Difficult bar introduction into
lathe spindle
Bar feeder not aligned with
lathe
Check and correct the alignment
Difficult bar introduction into
lathe collet
Excessive rag on bar fore end Trim rag before feeding