6 - USE AND OPERATION BOSS 332/545/552 HD
EN
6 - Pag. 13 / 24
6.5 BAR FEEDER SET-UP AND AUTOMATIC CYCLE START
The following list is a sequence of bar feeder setup and automatic cycle feeding operations
required if the bar feeder has to be started for the first time.
• Perform the software parameterization (refer to the "Keyboard Instruction Manual")
• Perform setup according to the bar to be machined (section "SETUP ACCORDING TO THE
BAR TO BE MACHINED" CH. 5)
• Prepare the bars to be machined (section "BARS TO BE MACHINED – FEATURES AND
PREPARATION", CH. 6).
• Load the bar magazine (section "BAR MAGAZINE - LOADING, CH. 6).
• Adjust the lubricating oil flow (section "LUBRICATING OIL - FLOW ADJUSTMENT", CH. 6).
• Start the automatic cycle (section "AUTOMATIC CYCLE START", CH. 6).
To Next Page
Loading...
