EN
6 - USE AND OPERATION BOSS 332/545/552 HD
6 - Pag. 20 / 24
6.7 AUTOMATIC CYCLE START AFTER MANUAL CYCLE OPERATIONS
• If the bar pusher has been moved while power supply was disconnected, the "BAR FEEDER
ZERO SETTING" should be performed as follows:
press the start buttons and
if the upper guide channels are not closed, the bar feeder
will not perform the "BAR FEEDER ZERO SETTING"; messages will be displayed about the
operations to carry out to bring the upper guide channels to the required position.
After carrying out the required operations:
• Press the start buttons and
.
• Check that the bar is in the required position in the lathe collet and that the collet is closed.
• Press
to select the automatic function; the bar feeder will wait for an "OPEN COLLET"
signal from the lathe.
6.8 AUTOMATIC CYCLE START - RESUMING WORK AFTER POWER-OFF
IF THE BAR PUSHER HAS BEEN MOVED WHILE POWER WAS DISCONNECTED
• Power the lathe on.
• Turn the main switch to position I (ON).
• Press
to start the bar feeder.
• Press to select the manual mode.
• Press the start buttons and
to perform the "BAR FEEDER ZERO SETTING".
• Move the bar in the lathe collet to the required position and make sure that the collet is
closed.
• Press
.
IF THE BAR PUSHER HAS NOT BEEN MOVED WHILE POWER WAS DISCONNECTED
• Power the lathe on.
• Turn the main switch to position I (ON).
• Press
to start the bar feeder
• Make sure that the lathe collet is closed.
To Next Page
Loading...
