EN
11 - COLLETS BOSS 332/545/552 HD
11 - Pag. 20 / 34
11.16 COLLETS FOR BARS 602P
11.17 COLLET FOR BARS - Table
WARNING – CAUTION:
the collet external diameter should be at least 0.5 mm smaller than the bar
pusher external diameter.
INFORMATION:
upon specific request, non standard collets with reduced thickness (which are
not mentioned in this table) may be supplied as well. Their durability is however
below the durability of standard collets.
Code structure
A Collet
B Bar diameter
C Example:
3 mm = 030
3.5 mm = 035
12.5 mm = 125
12.75 mm = 127
D Category
To Next Page
Loading...
