EN
11 - COLLETS BOSS 332/545/552 HD
11 - Pag. 26 / 34
11.22 COLLETS FOR BARS 076
11.23 COLLET FOR BARS - Table
WARNING – CAUTION:
the collet external diameter should be at least 0.5 mm smaller than the bar
pusher external diameter.
INFORMATION:
upon specific request, non standard collets with reduced thickness (which are
not mentioned in this table) may be supplied as well. Their durability is however
below the durability of standard collets.
Code structure
CH*: double-ended fork wrench DIN3110
A Collet
B Bar diameter
C Example
17 mm = 170
22.5 mm = 225
39.75 mm= 397
D Category
To Next Page
Loading...
