Ingenico Move 5000 - Replacing the Battery

Page 14
Move/
5000
User Guide
Copyright© 2019 Ingenico
Replacing the battery
It is imperative to use a battery authorized by Ingenico. There is
danger of explosion if the battery used is not approved by
Ingenico
• Remove the terminal from its base
• Turn it off by pressing and simultaneously for about one second
• Remove the back cover (see section ‘Installing the battery’)
• Carefully disconnect battery, following the instructions below
a) Unlock the connector by pressing the locking
mechanism as indicated by F1 arrow while pulling
this connector (F2 arrow) Release traction on it as
soon as the connector comes unclipped
b) Finish extracting connector by tilting it slightly (F3
arrow) to bring it away from the terminal housing
• Initialise the terminal for a replacement battery (*) by
placing it on its base, or connecting the terminal to a power supply without
a battery installed
• Connect and install the new battery by following the instructions in
‘Installing the battery’
• Close the back cover and charge the new battery. See ‘Charging the
Battery’
• In order to preserve the environment, dispose of the used battery at an
appropriate site in compliance with recycling legislation
(*) The terminal recognises that there is no battery when powering up.
It will then correctly perform a full recharge with the next battery installed