Ingenico Move 5000 - Waiter Setup (Function 40); Add Waiter Procedure

Page 77
Move/
5000
User Guide
Copyright© 2019 Ingenico
Function 40 Waiter Setup
A ‘Default Waiter ID’ exists to capture the gratuity amount from each transaction if
‘Gratuity’ is enabled on your terminal. However, you may wish to set up individual
‘Waiter IDs’ to record the amount of gratuity each waiter has accrued.
The ‘Waiter Menu’ will allow you to ‘Add, Delete, Print, Change Name, Delete All or
Create Defaults.
Press until the ‘Application Menu’ is displayed and enter the Function Code 40
as described previously above.
Add Waiter
Press to setup
waiters or press
or
to return to the ‘Idle
Prompt’.
Press when you
have typed in the
waiter’s name. The
details will be printed.
Touch ‘Add’ on the
screen to select it or
press to exit.
The details will be
printed before returning
to the ‘Waiter Setup
Menu’.
Start to type in the
‘Waiter’s Name’ as
described earlier in this
manual. The screen
will change to the
following:
Repeat for each waiter
to be added.
You may set up a
maximum of 99 waiter’s
names. Press
to exit
the menu.