Ingenico Move 5000 - Using Function Codes; Entering Supervisor Code

Page 75
Move/
5000
User Guide
Copyright© 2019 Ingenico
Function Codes
There may be occasions when you have further requirements of your terminal.
These can be met using Function Codes.
Function Codes other than the following should only be used on
the advice of the Helpdesk.
Entering Supervisor Code
You will be asked on occasions to enter your ‘Supervisor Code’, the following
screens will be displayed:
Type in your
Supervisor Code
and then press .
The screen will
display asterisks as
characters are
typed in.
Press to clear
one character at a
time
Press
to clear all
characters.
Press to confirm.
Function Codes
To access the ‘Function Codes Menu’, you must first go through the ‘Supervisor
Menu’. Press the button until the ‘Application Menu’ is displayed:
Touch ‘Supervisor
Menu’ on the
screen.
You will be
asked to enter your
‘Supervisor Code’.
Touch ‘Helpdesk
Menu’ on the
screen. The
‘Helpdesk Menu’
will open.