Protecting Local Disks
Intel
®
Entry Storage System SS4000-E User Guide 91
Additional Requirements
In addition to the system requirements, the following criteria must be met:
• You must be logged on as an administrator to install Intel
®
Client Backup and
Recovery and run it for the first time. However, after you run the application once as
an administrator, you can subsequently run it when logged on as a user.
• If your computer name includes any characters other than letters (A-Z or a-z),
numbers (0-9), hyphens (-), colons (:), or periods (.), you must change the computer
name before you use Intel
®
Client Backup and Recovery to protect a disk.
Note: Previous releases allowed the use of underscores (_) in the computer name. If
your computer name included this character and you protected a disk, you
must remove protection from all disks as described in “Removing Protection”
on page 126, delete the client from the storage system as described in
“Deleting a Client” on page 61, and protect the disks again as described in
“Protecting Your Disks” on page 98. When you protect your disks again, you
must remove the storage system from the list of backup locations and add it
again as described in step 4 in “Protecting Your Disks” on page 98.
• If you are using a firewall on the computer that you plan to protect, open TCP port
11762 on the firewall. This ensures that Intel
®
Client Backup and Recovery can
communicate with the storage system. Make sure your firewall does not block
incoming network communication to the Microsoft iSCSI Initiator*.
Installing the Microsoft iSCSI Initiator*
Before you can install Intel
®
Client Backup and Recovery, you must download and install
the Microsoft iSCSI Initiator* 2.x.
To download and install this initiator:
1. Open a Web browser, enter the following in the address bar, and press Enter:
http://www.microsoft.com/downloads/details.aspx?
FamilyID=12cb3c1a-15d6-4585-b385-befd1319f825&DisplayLang=en
2. Scroll down to the Files in This Download section and download the item that ends
in x86fre.exe.
3. Select the option to run the file. Run, Open, or Run this program from its current
location.
4. If a security warning displays, click Run. The installation wizard starts.
5. On the first page of the installation wizard, click Next.
6. On the page with installation options, click Next. Initiator Service and Software
Initiator are selected by default.
7. If a message box displays telling you to configure the settings in the Control Panel,
click OK.
Note: You do not have to configure the Microsoft iSCSI Initiator. Intel
®
Client
Backup and Recovery configures it for you automatically.
To Next Page
Loading...
Need help?
General