Protecting Local Disks
106 Intel
®
Entry Storage System SS4000-E User Guide
Stopping a Backup or Recovery in Progress
Once a backup or recovery starts, you can stop it at any time. For example, you may
decide to stop it if you notice that your system is not responding as quickly as you’d like,
and you want to free processing capabilities for other tasks.
When you stop a backup in progress, that backup does not display in the list of backups on
the Restore page, and any changed data that was not copied to the storage system is
copied during the next backup.
When you stop a recovery in progress, the local disk or partition is left in an incomplete
state, and you must recover it again later before you can use it.
To stop a backup or recovery in progress:
1. Click Status.
2. In the Protected disk list, select the disk whose backup or recovery you want to stop.
3. Click Stop Current Activity. If you are stopping a backup, the backup stops
immediately.
If you are stopping a recovery, a confirmation message displays. Click OK to stop the
recovery now, or click Cancel to proceed.
To Next Page
Loading...
Need help?
General