Adding or Replacing Hard Disks
Intel
®
Entry Storage System SS4000-E User Guide 133
Responding to RAID Failure
When disk removal/failure causes the entire RAID to fail, the Disk Change Notification
page displays when you access the Manager or refresh the browser window:
Take the appropriate action:
To do this Do this
Scan the storage system again and
update the information on the page
Click Scan.
Re-install the same disk Click Shut Down.
After the storage system shuts down, re-install the same disk
and then restart the system.
NOTE: If you removed multiple disks, you must re-install
them in the opposite order than you removed them.
Reconfigure the storage system using
the available disks
Click Reconfigure Disks and complete the system setup
pages as described in “Configuring Your Storage System” on
page 21.
Caution: Reconfiguring the storage system deletes all user
information and all data on all the disks.
To Next Page
Loading...
Need help?
General