Hardware Installations and Upgrades
Intel
®
Entry Storage System SS4000-E User Guide 145
continuous yellow, indicating a fault condition. If this occurs, remove the hard disk from
the storage system and check it or replace it with another hard disk.
When first installing hard disks to set up your storage system, the System Status LED turns
yellow to indicate the disks are not configured.
If you replace all of the hard disks with higher-capacity hard disks, you must go to
Administrator to login and reconfigure the disks.
Replacing Power Supply
The power supply is located on the back of the Intel
®
Entry Storage System SS4000-E.
Note: Replacement of the power supply should be done by qualified service personnel.
Note: Before performing any maintenance on the storage system, back up all data. Shut down
the storage system by selecting the Advanced tab from the Manager and then Shutdown
from the left-hand menu.
1. Observe all safety and ESD precautions listed in Appendix H, “Safety Information”.
2. Remove the new power supply from its protective packaging.
3. If you cannot shut down the system using the software Manager, then power down the
storage system by pressing and holding the power button for approximately five
seconds until the System Status LED starts flashing. The storage system shuts off after
a short shutdown period.
Caution: Ensure the system is completely shutdown before removing the power chord.
4. Disconnect the storage system from its power source.
To Next Page
Loading...
Need help?
General