Hardware Installations and Upgrades
Intel
®
Entry Storage System SS4000-E User Guide 137
7 Hardware Installations and
Upgrades
This chapter provides instructions for removing, installing, and replacing storage system
components in your Intel
®
Entry Storage System SS4000-E.
Note: Maintenance procedures should be done by qualified technical personnel.
Caution: It is recommended that you fit and check a suitable anti-static wrist and conductive foam
pad and observe all conventional ESD precautions when handling storage system
modules and components. Avoid contact with the backplane components and module
connectors.
Before You Begin
Before working with your storage system, review the important safety information listed
in Appendix H, “Safety Information”.
Tools and Supplies Needed
• Phillips* (cross head) screwdriver (#1 bit and #2 bit)
• Anti-static wrist strap and conductive foam pad (recommended)
System References
All references to the left, right, front, top, and bottom assume the reader is facing the front
of the storage system as it would be positioned for normal operation.
Removing or Installing the Enclosure Cover
Warning: The enclosure cover must only be removed by a service personnel. Potential hazards
include:
• Energy hazard
• Rotating fans
• Hot surfaces
• Access to power supply unit openings
Upon replacement, the cover MUST be secured by tightening the retaining screw with a
screwdriver.
To Next Page
Loading...
Need help?
General