Intel Stratix 10 Configuration User Guide

3.1.6.2.2. Creating Separate PFL II Functions
1. To create a PFL II instantiation, select Flash Programming Only mode.
2. Assign the pins appropriately.
3.
Compile and generate a .pof for the flash memory device. Ensure that you tri-
state all unused I/O pins.
4. To create another PFL II instantiation, select Configuration Control Only mode.
5. Instantiate this configuration controller into your production design.
6. Whenever you must program the flash memory device, program the CPLD with the
flash memory device .pof and update the flash memory device contents.
7.
Reprogram the host with the production design .pof that includes the
configuration controller.
Note: All unused pins are set to ground by default. When programming the
configuration flash memory device through the host JTAG pins, you must tri-
state the FPGA configuration pins common to the host and the configuration
flash memory device. You can use the pfl_flash_access_request and
pfl_flash_access_granted signals of the PFL II block to tri-state the
correct FPGA configuration pins.
3.1.6.2.3. Programming CPLDs and Flash Memory Devices Concurrently
You can either program the CPLD and the flash memory concurrently or separately. To
program concurrently, first program the CPLD, then the flash memory device. Follow
these steps:
1.
Open the Programmer and click Add File to add the .pof for the CPLD.
2. Right-click the CPLD .pof and click Attach Flash Device.
3. In the Flash Device menu, select the density of the flash memory device to be
programmed.
4. Right-click the necessary flash memory device density and click Change File.
5.
Select the .pof generated for the flash memory device. The .pof for the flash
memory device is attached to the .pof of the CPLD.
6. Add other programming files if your chain has other devices.
7.
Check all the boxes in the Program/Configure column for the new .pof and
click Start to program the CPLD and flash memory device.
3.1.6.2.4. Programming CPLDs and Flash Memory Devices Separately
To program the CPLD and the flash memory devices separately, follow these steps:
1. Open the Programmer and click Add File.
2.
In the Select Programming File, add the targeted .pof, and click OK.
3.
Check the boxes under the Program/Configure column of the .pof.
4. Click Start to program the CPLD.
5. After the programming progress bar reaches 100%, click Auto Detect.
3. Intel Stratix 10 Configuration Schemes
UG-S10CONFIG | 2018.11.02
Intel Stratix 10 Configuration User Guide
Send Feedback
44

Intel Stratix 10 Specifications

General

Brand	Intel
Model	Stratix 10
Category	Control Unit
Language	English