EasyManuals Logo

Intermec EasyCoder PX6i Service Manual

Intermec EasyCoder PX6i
282 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
EasyCoder PX4i and PX6i Service Manual 95
Chapter 8 — Print Unit
Sensor Replacement
Before replacing the sensor, check that the sensor arm is properly adjusted
and that the sensor is free from dust, paper shreds, and other things that
can block the light.
Replace the sensor as follows:
Switch off the power, remove the power cord, and remove the cover over
the electronics compartment.
Check that the printhead is lowered.
Remove the #T10 Torx screw that holds the front of the sensor.
• Raise the printhead.
Remove the #T10 Torx screw that holds the rear of the sensor.
Pull out the sensor and disconnect its cable from the CPU board.
Reassemble in reverse order. The sensor’s cable should be connected to
J58 (marked “HEADLIFT”) on the CPU board.
In Fingerprint, check that the sensor works properly using a PRSTAT
statement, see Intermec Fingerprint v8.xx, Programmer’s Reference
Manual.
In IPL, check that the sensor works properly using the Label Path Open
Sensor Value command (<STX>L<ETX>), see IPL Programming, Refer-
ence Manual.

Table of Contents

Other manuals for Intermec EasyCoder PX6i

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intermec EasyCoder PX6i and is the answer not in the manual?

Intermec EasyCoder PX6i Specifications

General IconGeneral
Print technologyDirect thermal
Maximum resolution203 x 203 DPI
DisplayLCD
Product colorSilver
Standard interfacesRS-232, USB 2.0
Internal memory16 MB
Media thickness2.4/10 mm
Maximum label width170 mm
Maximum label length4 m
Maximum roll diameter213 mm
Maximum internal memory1 GB
Supported network protocolsTCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements90 - 265 VAC, 45 - 65Hz
Power consumption (standby)20 W
Power consumption (printing)125 W
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)40 - 104 °F
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Depth482 mm
Width238 mm
Height335 mm
Weight14800 g

Related product manuals