Intermec EasyCoder PX6i Service Manual

124 EasyCoder PX4i and PX6i Service Manual
Chapter 11 — Paper Cutter
11.6 Spring Replacement
The spring that presses the anvil blade against the rotating shear may
eventually get slack, especially if the anvil blade is forced open, for example
during cleaning. A slack spring must be replaced as follows:
• Remove the right-hand gable of the cutter (two #T20 Torx screws).
• Remove the right-hand gable of the cutter mechanism (two #T20 Torx
screws + three Posidrive screws).
• Replace the spring and assemble in reverse order, making sure to put
back all the washers.

Intermec EasyCoder PX6i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.4/10 mm
Maximum label width	170 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	20 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	482 mm
Width	238 mm
Height	335 mm
Weight	14800 g