Intermec EasyCoder PX6i Service Manual

232 EasyCoder PX4i and PX6i Service Manual
Chapter 17 — Troubleshooting
Headlift Sensor
Description:
• The printer does not work, although the printhead is lowered.
• Error condition 1022 “Head lifted” (FP) or “Print Head UP/Press Feed”
(IPL) is indicated at any attempt of printing a label.
Possible Causes and Suggested Remedies:
• Headlift sensor blocked.
- Check the sensor for dust or foreign objects.
• Bad connection.
- Check that the sensor’s cable is connected to J58 on the CPU board.
Inspect cable for damage.
• Faulty sensor.
- Replace as described in Chapter 7.8.
Label Taken Sensor (LTS)
Description:
The label taken sensor (LTS) is not working properly.
Possible Causes and Suggested Remedies:
• Intermec Fingerprint instruction missing.
- The LTS must either be enabled using an LTS& ON statement, or
the status of the LTS must be polled using a PRSTAT function in the
current Intermec Fingerprint program.
• IPL instruction missing.
- The self-strip mode must be enabled using the commands
<STX>R<ETX> and <STX><SI>t1<ETX>.
• Bad connection.
- Check that the LTS is correctly connected to J53 on the CPU board.
- Check that the cable between CPU board and sensor is not damaged.
• Dirty sensor.
- Make sure that the active parts of the sensor are not obstructed by
dust or foreign objects.
• Wrong LTS sensitivity.
- The sensitivity of the sensor’s receiver and the light intensity of the
sensor’s emitter are adjustable, see Chapter 10.4.
• Interference from sunlight or lamps.
- Shield the sensor from interfering light source.
• Defective sensor.
- If still no reaction, the sensor is probably defective. Replace.

Intermec EasyCoder PX6i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.4/10 mm
Maximum label width	170 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	20 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	482 mm
Width	238 mm
Height	335 mm
Weight	14800 g