Intermec EasyCoder PX6i Service Manual

EasyCoder PX4i and PX6 Service Manual 213
Chapter 17 — Troubleshooting
17.2 No Reaction at Power Up
Description:
There is no visible reaction when the power to the printer is switched on.
• The Power LED does not light up.
• There is no text in the display window.
Possible Causes and Suggested Remedies:
• No power in AC wall socket.
- Check with some other electrical device or a voltage meter.
• Power cord connectors not completely inserted in printer’s power cord
receptacle or in wall socket.
- Disconnect and fi rmly connect both ends of power cord. Try again.
• Faulty power cord.
- Replace and try again.
• Cables between power supply, driver board and CPU board not prop-
erly connected.
- Test as described in Chapter 17.5 using test points on CPU board
(see Chapter 15.5).
• Power Supply overload.
- Too high a temperature in the power supply unit. Leave the power
on and wait for the power supply to cool off (may take up to half
an hour). When the temperature returns to normal, the printer will
automatically restart. If the error persists, examine the power supply
as described in Chapter 17.5.
• Faulty power supply unit.
- Refer to Chapter 17.5.
• Faulty driver board.
- Refer to Chapter 17.6.
• Faulty console unit.
- Refer to Chapter 17.7.

Intermec EasyCoder PX6i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Product color	Silver
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.4/10 mm
Maximum label width	170 mm
Maximum label length	4 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	20 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	482 mm
Width	238 mm
Height	335 mm
Weight	14800 g