EasyManua.ls Logo

Intermec EasyCoder PX6i - No Communication (General)

Intermec EasyCoder PX6i
282 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
224 EasyCoder PX4i and PX6i Service Manual
Chapter 17 — Troubleshooting
17.9 No Communication (general)
Description:
The following actions are valid for all communication interfaces installed
in the printer.
Possible Causes and Suggested Remedies:
Defective cable between printer and host.
- Check that the communication cable is correctly inserted and that it
is of the correct type and is correctly confi gured.
- Check that any clips or ground screws are properly engaged.
- Inspect cable for physical damage.
- Disconnect and connect the cable a few times to rub off possible
oxide from the connectors.
- Try using another identical cable.
Defective cable between interface board and CPU board. This does not
apply to the serial port ("uart1:"), the USB port, or any EasyLAN board
which all are fi tted directly on the CPU board.
- Check that the cable is connected correctly.
- Inspect cable for physical damage.
- Disconnect and connect the cable a few times to rub off possible
oxide from the connectors.
- Replace the cable.
Error in host.
- Try connecting the printer to another host computer.
• Erroneous data.
- If using Fingerprint, check if the data string contains the correct char-
acters using the Line Analyzer program included in Intermec Shell
(see the User’s Guide).

Table of Contents

Other manuals for Intermec EasyCoder PX6i

Related product manuals