EasyManua.ls Logo

Intermec EasyCoder PX6i - Easylan Ethernet Interface Board

Intermec EasyCoder PX6i
282 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
198 EasyCoder PX4i and PX6i Service Manual
Chapter 16 — Interfaces
16.9 EasyLAN Ethernet Interface Board
Description
This section describes how to install an EasyLAN Ethernet network inter-
face in an EasyCoder PX4i and PX6i printer and how to connect it to a
100base TX Fast LAN, WAN, Intranet, or Internet network via a wired
connection.
The installation instructions describes how to physically install the inter-
face board in a printer. Confi guration and setup are described in the
EasyLAN Interface Kit, Installation Instructions and the Intermec EasyLAN,
User’s Guide on the attached CD-ROM.
This interface kit must only be physically installed by an authorized
service technician.
Printer Firmware
The printer must either be fi tted with Intermec Fingerprint v8.30 (or
later) or IPL v2.30 (or later). In Intermec Fingerprint, the network port is
addressed as device "net1:" (communication channel #5).
Installation Kit
The EasyLAN Interface Kit contains:
One EasyLAN interface board
One light guide
One hexagonal threaded spacer
One network extension cable
One cable tie
One serial number label
One CD-ROM with software and manuals
One Installation Instruction booklet
The only tool required for the installation is a #T20 Torx screwdriver.

Table of Contents

Other manuals for Intermec EasyCoder PX6i

Related product manuals